Dairy Hub

Barns, Cow Comfort & Equipment

Barn Planning for Mountain West Snow and Wind

Holstein cow in a robotic milking stall

A dairy barn in Idaho, Utah, Colorado, Wyoming or Montana has to handle things a barn in Georgia never worries about: heavy snow on the roof, wind that arrives sideways at highway speed, deep frost, big temperature swings and drifts that appear overnight. Design for the worst storm your site has seen, not the average winter. Then call a structural engineer, because snow load and wind rules are set by local code and vary by county and elevation.

The general plan is simple: put the barn where wind and snow work for you, build it strong enough to carry the loads, keep the cow areas open to fresh air, and make sure water, drainage and manure systems still work at the coldest point of the year.

Wind in the Mountain West is not weather. It is a personality. It will find the one door you did not latch.

Start with the site

Where you place the barn matters nearly as much as how you build it. Walk the property in the worst weather if you can, and talk to neighbors who have lived there a while.

  • Prevailing wind and storm direction. Orient the long axis so the barn gets good airflow without taking every storm broadside. Your designer will look at local wind data and the shape of the land.
  • Drift zones. Snow piles up on the downwind side of buildings, hills and tree lines. Do not put a main road, a feed lane or a calving area where drifts always form.
  • Drainage. Snowmelt is a big water event in spring. The site should shed meltwater away from barn floors, feed storage, lagoons and wells. Grade for it before you build.
  • Spacing between buildings. Buildings too close together block airflow and collect drifts and manure moisture between them.
  • Access. Feed trucks, milk trucks and plows need a route that stays open. A milk truck that cannot reach the farm is a bad day for everyone.

Snow load and roof design

Roof snow load is set by building codes and local conditions and can vary enormously across short distances as elevation changes. Your county building department, a barn builder or a structural engineer will give you the design value for your site. Do not copy the plans from a barn in a different valley and assume the roof will carry the same load.

Think about how snow leaves the roof as well. A roof that sheds snow can bury a sidewall curtain or a doorway, or pile up where cows and people walk. A roof designed to hold snow needs the strength to do it. In either case, plan where the snow will go. Add snow guards or place walkways away from slides when it is warranted.

In general, buildings with open ridges and sidewall openings for ventilation should still be designed by someone who understands how those openings affect loads. Ask the engineer directly.

Wind, bracing and openings

Mountain West winds can be strong, gusty and unpredictable. Open-sided barns collect wind in the building, and large curtains act like sails. Good design pays attention to bracing, anchorage, curtain hardware and how the structure behaves when openings are partly open.

  • Use windbreaks, solid or porous, upwind of cow areas to cut the wind speed before it reaches them. Porous barriers often work better than solid walls since they reduce turbulence.
  • Make sure curtains, doors and fasteners are rated for the wind, and set up an easy way to close them during a blow.
  • Check cattle handling areas for protection from side winds at exits and holding pens.

Cold and ventilation

Cold alone is not the problem for cows, as discussed in cold-weather freestall management. Moisture is. Mountain West barns still need open ridges and enough sidewall opening to remove humidity, which makes the combination of wind control and ventilation the real design puzzle. Winter ventilation: keeping barns open and dry explains how to set openings, and natural ventilation in freestall barns explains why.

The high, dry climate has its own twist: summer days can be hot while nights cool off quickly. Plan for shade, fans and soakers on the hottest weeks, and enough closeable sidewall to handle a cold night. Large daily temperature swings mean curtains need adjusting more often, which is a good argument for automatic controllers.

Frost, concrete and water

Deep frost heaves footings, cracks slabs and freezes lines. Foundations need to go below local frost depth, and water lines need burial depth and insulation to match. Drains, scrapers and waterers all need a plan for the coldest week of the year.

  • Insulate and heat waterers, or use flow systems that do not freeze.
  • Protect valves, hydrants and flush lines.
  • Think about manure systems that keep moving in cold weather. Frozen manure piles and stuck scrapers are a classic problem.
  • Be careful with concrete placed in cold weather and with the finish for alleys. See grooved concrete vs rubber alleys for traction and wear issues.

Hard water is another regional concern. It affects equipment, cleaning and sanitizer performance, which is covered in hard water and dairy cleaning in the Mountain West. Western water rights are a business question as well, so water costs and rights for western dairy farms deserves a read before you size a new herd.

Budget and permits

A barn built for snow and wind costs more than one built for mild country, and the difference is in steel, footings, bracing and snow-rated trusses. Get firm bids from contractors who have built dairy barns in your area, and be skeptical of the one whose plans look like a different state. For ballpark line items, see how much a freestall barn costs per cow.

Permits vary. Counties may have building permits, setbacks, manure storage rules and water quality requirements, and the state dairy or ag department may have its own. Ask early. NRCS can provide conservation planning and sometimes cost-share on manure storage and related practices through your local field office at the NRCS website, and Utah State University Extension has regional dairy and livestock resources at USU Extension.

A short planning checklist

  1. Get the local snow and wind design values from the building department or an engineer.
  2. Walk the site in bad weather and map drifts, drainage and wind.
  3. Locate the barn, roads, feed storage and manure storage with storms in mind.
  4. Design the ventilation and wind protection together.
  5. Plan water, drains and manure for deep cold.
  6. Price the barn with realistic bids and check permits early.

Quick answers

How do I find the snow load for my site?

Ask your county building department or a structural engineer. Snow load depends on local code and elevation, and it can differ even between nearby valleys.

Should a Mountain West barn be closed or open?

Usually open enough to ventilate, with curtains or windbreaks that can be adjusted for storms. Cows handle cold well but need fresh, dry air, so full enclosure is rarely the answer.

What is the biggest planning mistake?

Designing for average weather. Plan for the worst storm and the coldest week, and make sure water and manure systems keep working then.

More from farm.FM Need a break from the paperwork? Farm humor and funny farm stories are always in season at farm.FM.